Reduced Kernel Size – 2021 Harvest

There have been several reports of smaller than expected nut size for the 2021 harvest. Nonpareil sizes have been reported to be in the range of 28-30/ounce rather than the typical 24/25 nuts per ounce. Many have suggested that this is due to drought induced water shortages, but this has occurred even on fully irrigated orchards. Water stress has played a role, but earlier conditions of the season should also be considered. Nut weight is influenced by a few different factors. These include: Reduced number of cells; Reduced cell size; Reduced cell weight. Cell number is mostly impacted by temperatures that occur during cell division, which occurs early in the season, typically within 6-8 weeks following fertilization. Cell enlargement is influenced by plant stress. It begins in April and continues through May. Lastly, weight accumulation begins in May and continues until early August. It is influenced by plant stress, which reduces the production of carbohydrates. To maximize nut size, carbohydrates (sugars) must be available during these periods for cell building processes. Carbohydrate availability is influenced by the rates of photosynthesis and respiration. These two processes are heavily influenced by plant temperature, which are influenced by ambient air temperature and water availability. Temperature influences photosynthesis and respiration. Both processes increase rapidly as temperatures warm, and begin to drop as temperatures increase above a certain point. The peaks, however, are different, with 86F and 103F for photosynthesis and respiration, respectively (figure 1). Since these peaks are different, there is a net gain of carbohydrates when temperatures are below 86F, but a net loss as temperatures increase above this point. Furthermore, as temperatures warm towards 86F, there is more energy being directed towards respiration, which reduces availability to be used for other processes, like nut development and plant growth. Internal plant temperature is

Read More

Catch frame shaker sets in almonds?

Almonds are typically shaken to the ground by a side mount or boom shaker, allowed to dry where they fall for several days to weeks — depending on drying conditions and ant pressure – and then windrowed and picked up.  Once nuts are on the ground, no water should be applied to the orchard to avoid wetting nuts on the ground.  Depending on local conditions – how dry the soil was ahead of harvest as well as weather after shaking, if irrigation is applied between harvests of different varieties, etc.  – traditional harvest practices can result in water stress in the orchard, leading to measurable yield reduction in future years. Recently, some growers have moved to shaking and sweeping within 24 hours. The windrows are then conditioned (picked up, leaves and dirt blown out and dropped back on the orchard floor in a wide, shallow windrow) and left to dry out in the orchard middles.  Growers with micro- irrigation can irrigate (at least a little) once the windrows are down, reducing water stress in the orchard compared to a traditional shake-dry-windrow-pickup harvest.  This practice can reduce the time between shaking and pickup by 48 hours. Another alternative to traditional almond harvest is the use of catch frame shaker sets instead of shake-to-the-ground (no catch) machines (see photo).   Catch frame shaker sets (two machines; a shaker side and a receiver side) are used to harvest prunes and pistachios up and down the state.  Recently I watched a stock prune/pistachio catch frame set harvest almonds in a mature (10th leaf) orchard on Lovell rootstock on Class 2-3 soil at the Nickels Soil Lab near Arbuckle.   This orchard recently had the buried drip hose replaced and the orchard floor surface was rough under the trees.  A catch frame harvest was used to get

Read More