Almond Frost Warning and Protection Methods - 2018

The upcoming week will see temperatures drop to the mid-20's. With the current almond crop stage, damage and losses may occur if mitigation practices aren't utilized. Below is a list of previously written entries to provide guidance on when to start, how much to irrigate, and other practices to utilize to mitigate frost damage.The point to turn on irrigation is dependent on dew temperature and the expected low temperature. Starting the irrigation too late when the dew temperature is low can increase the risk of damage. Turning off too early can also increase the risk of damage. Techniques utilized to determine when to start and turn off irrigation usually revolve around the use of a "wet bulb." More can be found in this article written by Dr. Richard Snyder, a bio-meteorologist at UC Davis.Irrigation application rates need to be high enough to provide an increase in air temperature. Application rates should exceed 30 gallons per minute per acre. Rates less than 15 gallons per minute per acre may lead to freezing of irrigation lines/spaghetti tubing. More on this can be found within this article.The critical temperature of damage will vary by bloom stage and variety. Tests to determine the sensitivity of some varieties has been conducted and can be found on this table. At full bloom, temperatures at or below 27-28F  can cause crop loss. As trees leaf out and nuts begin to develop, the sensitivity to cold temperature increases.There are a few practices that should be implemented to reduce damage. These are outlined in this article. Please note that in flood and drip-irrigated orchards it may not be possible to have high enough discharge to have a warming effect of the water, but adding moisture to the soil can increase the warmth of the field - which is why mowing any vegetation is advised within these systems. Mowing may not be as critical in orchards that are able to apply irrigation water over the top of a cover-crop.