Shothole borer damage on Almond – Varietal Differences in Response to Water Stress

The water crisis on the West side of the valley has presented opportunities to see problems not typically observed in almond production. Many of these issues tend to be directly related to tree stress caused by lack of water, failure of salt leaching due to decreased winter rains, and chronic water stress from prolonged drought. Typical observations of drought stressed trees range include yellowing leaves and leaf drop in mild cases, wilted new growth during moderate stress periods, and poor crop set, thinned canopy, and scaffold die back in chronic cases. A visit was made to an Aldrich-Monterrey-Nonpareil orchard located near Los Banos, CA. All varieties were on Nemaguard rootstock. This orchard has been under moderate drought stress for the past two years as determined by the use of a pressure bomb. This year, the grower was again short on water and had to water at about 80% evapotranspiration rate for the season. The grower was concerned about clear gumming coming from multiple wounds on his trees. Orchard observations included those listed above for orchards suffering from chronic drought stress: poor vigor, thinned canopies, and reduced crop load. On the affected trees, gumming was seen extending form the graft union up to the scaffolds. The issue was predominantly found on Aldrich trees, with some strikes on the Nonpareil, and very few, if any, strikes on the Monterrey. Upon seeing the damage (Picture 1), it was very clear that it was shothole borer, Scolytus rugulosus, an insect that invades and lays eggs in the branches/trunks of stressed trees. Borer insects are able to push their eggs through the bark and into the tree. A tree that is healthy enough to elicit a response then gums profusely in order to flush the egg out of the tree’s tissue (Picture 2). This gum

Potassium thiosulfate toxicity on almond

During periods of high heat and the corresponding high evapo-transpiration, several unique orchard problems can occur. Most of these are due to fertigation methods which have been widely adopted to increase fertilizer application efficiency. The benefits of fertigation greatly outweigh most negative impacts, but caution must be used as a simple mis-calculation can cause orchard damage. A field call from a grower in late June demonstrated the potential problems that can occur with fertigation. Observations of yellowing leaves, leaf drop, and death of lower limbs raised concerns by the grower and pest control advisor (PCA), prompting an orchard visit. Initial Observations: Upon arriving to the 11th leaf Sonorra/Nonpareil/Carmel (all on Nemaguard) orchard I noticed excessive leaf drop across all varieties (Picture 1). Most of these leaves were coming from the interior of the canopy, suggesting the possibility of drought stress from improper irrigation scheduling. Lower leaves found on the interior of the canopy were burnt back, with a crispy texture. Leaves closest to the trunk that were completely yellow were beginning to abscise, while leaves on the tips of the branches remained green (Picture 2). This is in contrast to lower limb dieback, which causes soft yellow leaves found on the ends of interior branches. Picture 1: Leaf drop associated with the over-application of potassium thiosulfate. Picture 2: Leaf wilting and “dieback” associated with the over-application of potassium thiosulfate. Note how the interior branches are more affected than the branches on the outside edge of the canopy. Up-Close Observations: Close inspection of the leaves revealed a necrotic tip, or burnt region of the leaf. This leaf was surrounded by a yellow halo (Picture 3). Typically, a yellow halo around a necrotic area would suggest the possibility of almond leaf scorch, but due to the widespread occurrence of the problem, this